Filter
Top Products
8
| OPERATING INSTRUCTIONS - Using Your Ultrasonic
Humidifier and Night Lamp |
5. After you have chosen your favorite shade of color, allow the LED lights to rotate between colors
and push the ON/OFF Night Lamp Button as soon as you see your favorite color. This will stop the
rotation at the chosen color.
6. To resume rotation, push the ON/OFF Night Lamp Button again.
7. Hold the ON/OFF Night Lamp Button for two seconds to turn off the night lamp.
E. How to add Aroma Oils to Humio
1. Unplug the unit from the wall outlet.
2. Locate the Aroma Oil Compartment on the base of the unit.
3. Slide open the Aroma Oil Compartment by firmly holding the unit in place and pulling the Aroma Oil
Compartment outward (towards you).
4. Add a few drops of your favorite aroma oil to the sponge until well absorbed.
5. Close the Aroma Oil Compartment by sliding the Aroma Oil Compartment back into the base of the
unit.
6. Add water to the water tank by following the instructions on page 6 section A.
7. Place the unit on an even stable surface.
8. Plug the unit back into the wall outlet.
9. Turn on the humidifier function. Aroma from the oils in the compartment will be mixed with the
circulated air coming from the vent of the oil compartment. The normal flow of air
will then join with the cool mist from the humidifier ultimately adding aroma to the moisturized air.
F. Proper Care, Cleaning and Maintenance
CAUTION: ALWAYS TURN THE POWER OFF AND DISCONNECT THE POWER CORD FROM THE
ELECTRICAL OUTLET BEFORE CLEANING.
The following general rule should apply to the proper care, cleaning and maintenance of Humio -
clean daily and sanitize weekly or when Humio will not be used for several days or stored away.
Please note, if water remains in the Water Tank for more than 24 hours, bacterial growth is possible.
Do not leave water in the Water Tank for more than 24 hours when not in use.
Daily Maintenance:
1. Unplug Humio.
2. Remove the Water Tank from the Motor Base.
3. Empty all the water from the Motor Base and the Water Tank.
4. Wipe all surfaces with a clean, soft towel.
5. Refill with clean water.
Weekly Maintenance:
1. Unplug Humio.
2. Remove the Water Tank from the Motor Base.
3. Empty all the water from the Motor Base and the Water Tank.
4. Do not immerse the Motor Base in water.