Filter
Top Products
-4-
V. b-REPLACING THE GASKETS:
To remove the gasket to be replaced, grasp it rmly by
one corner and pull it out. Before attempting to install
a new gasket, both the unit and the gasket itself must
be at room temperature. Insert the four corners rst by
using a rubber mallet (or hammer with a block of wood).
After the corners are properly inserted, work your way
towards the center from both ends by gently hitting with
a mallet until the gasket is completely seated in place
(see gure below for proper gasket placement).
NOTE: The gasket may appear too large, but if it is in-
stalled as indicated above it will slip into place.
V. c-CLEANING THE CABINET SURFACES:
Disconnect electrical power supply
before cleaning any parts of the unit.
Exterior stainless steel should be cleaned with warm wa-
ter, mild soap and a soft cloth. Apply with a dampened
cloth and wipe in the direction of the metal grain.
Avoid the use of strong detergents and gritty, abrasive
cleaners as they may tend to mar and scratch the sur-
face. Do NOT use cleansers containing chlorine, such
as bleach, this may promote corrosion of the stainless
steel.
Care should also be taken to avoid splashing the unit with
water, containing chlorinated cleansers, when mopping
the oor around the unit.
For stubborn odor or spills, use baking soda and water
(mixed to a 1 tablespoon baking soda to 1 pint water
ratio).
A stainless steel polish is recommended for shining of
unit.
SIDE DOOR PANEL
GASKET ASSEMBLY
VERTICAL GASKET
RETAINER
VI. a-DOOR:
Your Traulsen Full Size Undercounter Quick Chiller model door
is eld re-hingeable. If re-hinging is required, please contact our
in-house service department at 800-825-8220 for instructions.
V. CARE & MAINTENANCE (cont’d) VI. DOOR