Filter
Top Products
7 of 12
6. Associate each thermostat to the Controller.
a. In the Vizia RF+ software right click on the VRC0P module under All Devices in the
programming tree.
b. Select RS-232 Setup from the menu.
c. In the LevSerialInterfaceConfig dialog box:
i. Verify that the RS-232 Module drop down shows that the VRC0P module is
selected.
ii. Check the box for each thermostat Node ID to be associated to the VRC0P
module.
iii. Click the Set Association button.
iv. Close the dialog box.
7. Test all devices for proper operation. Select each thermostat from the All Devices node of the
programming tree and change modes (heat, cool, fan, etc.) for each thermostat on your network.