Filter
Top Products
8
1
Prepare the bridge for enrollment. (Bridge kit SK101 purchased
separately)
Î Note: If the bridge is already installed, follow the instructions as they are
written in the following steps. If the bridge is not installed, follow the instruc-
tions shipped with the bridge kit.
a. Unplug Ethernet and power cables from bridge.
b. Install a quality 9 volt battery.
c. Verify that blue light is blinking. If blue light is solid, battery is dead.
d. Take bridge to the location where the Comfort Control is mounted.
Blue
light
Battery
Enroll Comfort Control into existing Z-Wave Network (Nexia
TM
Home Intelligence)
2
Enroll the Comfort Control into the bridge. (Inclusion)
If you are using a controller that is not a Nexia
TM
bridge, consult the instructions
that shipped with the controller to nd out how to enroll a new device.
a. Hold the bridge within 6 feet (1.8 meters) of the Comfort Control throughout
steps “b” through “f”.
Î After you begin the enrollment process, you have 30 seconds to complete
the remainder of the steps. Study the steps below before beginning.
b. Press and release the plus (+) button on the bridge.
c. Press the MENU button on the Comfort Control.
d. Press the NEXT button to advance to the Z-WAVE menu.
e. Press SELECT
f. Observe the lights on the bridge. The orange light will blink while enrollment
is taking place. Enrollment is complete when the orange light becomes solid.
Gateway
“+” Button
3
Verify enrollment of the Comfort Control.
a. Press Menu Button on the main Comfort Control screen.
b. Press the Next Button to advance to the About screen and press the Select Button.
c. Press the Next Button to advance through the menu options to Node ID
• If the number listed there is anything other than “00”, the Comfort Control has been successfully enrolled.
• If the number listed there is “00”, the Comfort Control has NOT been successfully enrolled. In this case, repeat step 18 and verify
again.
d. Press Done button 2 times when nished.
Item Description
VERSION 010000 Firmware version (number may vary)
ZWAVE VER 034006 Z-Wave version (number may vary)
NODE-ID 01 Z-Wave node ID (number may vary)
HOME-ID 00000000 Z-Wave Home ID (number may vary)
OUT-TYPE AC Outdoor type may be AC, HP or NONE
C/O WITH COOL Energize Reversing Valve with COOL or with HEAT (HP only)
IN-TYPE GAS/OIL Indoor type may be GAS/OIL, ELECTRIC or HYDRONIC
User Guide