Filter
Top Products
94 RTAC-SVX01F-EN
Controls Interface
The ALARMS button appears only when an alarm is present, and blinks (by alternating
between normal and reverse video) to draw attention to a diagnostic condition. Press
-
ing the ALARMS button takes you to the corresponding tab for additional information.
Front Panel Lockout Feature
Display and Touch Screen are Locked
Enter Password to Unlock
1
4
7
8
5
2
6
3
9
Enter 0 Cancel
NOTE: The DynaView display and Touch Screen Lock screen is shown below. This
screen is used if the Display and touch screen and lock feature is enabled. Thirty
minutes after the last keystroke, this screen is displayed and the Display and Touch
Screen is locked out until the sequence “159 <ENTER>” is pressed.
Until the proper password is entered, there will be no access to the DynaView
screens including all reports, setpoints, and Auto/Stop/Alarms/Interlocks.
The password “159” is not programmable from either DynaView or TechView.
Front Panel Display During Cold Ambients
Display and Touch Screen are Locked
Enter 159 to Unlock
1
4
7
8
5
2
6
3
9
Enter 0 Cancel