Filter
Top Products
Toshiba
–5–
Air-dischage direction kit
Installation Manual
Setting the louver lock (Louver position fixing)
• Fix the louver at the air flow blockage portions. (For the setting methods, follow the procedures below.)
1 Push the LOUVER (Right button) for more than
4 seconds while the air conditioner is stopped.
The blinks.
2 Push the UNIT (Left button) to select the indoor
unit you want to set.
Every time you push the button, the Unit No. changes.
The fan of the selected indoor unit starts its operation and the
louvers swing.
3 Push the TEMP. / buttons to display the
louver No. with the wind shield applied.
The selected louver starts to swing.
4 Select the code 0001 by pushing the TIME /
buttons.
5 Push the button to define the setting contents.
After the setting contents is defined, the mark lights.
(Return to step
3 if there are other two wind shields.)
6 Push the button to exit the setting.
“F1” is displayed in the CODE No. on the remote controller
display.
This means that the 01 louver shown on the illustration is
selected.
Confirming the installation
• After the installation completes, perform the test run to confirm that no abnormality is found.
• For your future reference, please keep the installation manual on your side.
Unit No.
1-1
Unit No.
1-4
Unit No.
1-2
Unit No.
1-3
F1
F4
F2
F3
Louver fixing position code
Louver No.
Electric parts box
Refrigerant piping
Drain piping
(Louver No. diagram)
5-EN
+00EH99678401.BOOk Page 5 Friday, November 13, 2009 2:38 PM