Filter
Top Products
– 154 –
No.
Part name
Front cabinet
Procedure
1. Detachment
1) Perform work of item 1 of .
2) Remove screws (ST1T Ø4 x 10L, 2 pcs.)
of the front cabinet and the inverter cover.
3) Take off screws of the front cabinet and
the bottom plate. (ST1T Ø4 x 10L 3 pcs.)
4) Take off screws of the front cabinet and
the motor support.
(ST1T Ø4 x 10L, 2 pcs.)
• The left side of the front side if made to
insert to the rear cabinet, so remove it
pulling upward.
3. Attachment
1) Insert hook at the left side of the front side
into the rear cabinet.
2) Hook the lower part at the right side of the
front to concavity of the bottom plate.
Insert the hook of the rear cabinet into the
slit of the front cabinet.
3) Attach the removed screws to the original
positions.
Remarks
For single-phase type models,
also take off this screw
Motor support
Front cabinet
Front cabinet (Left side)
Slit Claw
Cord clamp
Slit
Hook
Front cabinet
Lower
slit
Concavity at
bottom plate