Toshiba RAS-10JKVP-E Air Conditioner User Manual


 
7
ENGLISHFRANÇAISDEUTSCHITALIANOESPAÑOLNEDERLANDSPORTUGUÊSΕΛΛΗΝΙΚΗ
EN
Location of the remote control
Keep the remote control where its signals can reach the receiver of the indoor unit
(a distance of up to 7 m is allowed).
When you select timer operation, the remote control automatically transmits a
signal to the indoor unit at the specified time.
If you keep the remote control in a location where proper signal transmission is
blocked, a time lag of up to 15 minutes may occur.
Remote control holder
Installing the remote control holder
Before you actually install the remote control holder on a wall or pillar, check
whether the remote control signals can be received by the indoor unit.
Mounting and removing the remote control
To mount the remote control, hold it parallel to the remote control holder and push
it in fully. To remove the remote control, slide the remote control upwards and out
from the holder.
USING THE REMOTE CONTROL
CAUTION
The air conditioner will not operate if curtains, doors or other objects block the signals from the remote control to the indoor
unit.
Be careful that liquids do not spill onto the remote control.
Do not expose the remote control to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly.
Use curtains to prevent sunlight from reaching the receiver.
Signals may not be properly received, if the room using the air conditioner has fluorescent lighting with electronic starters. If
you are planning on using fluorescent lamps, consult with your local dealer.
If other electrical appliances are activated by the remote control, move these appliances or consult with your local dealer.
7 m
01_EU_RAS-10JKP_EN.fm Page 7 Wednesday, April 9, 2003 8:08 AM