Filter
Top Products
– 89 –
1
Torque~12N·m
2
1
2
3
Torque~12N·m
No.
2
Part name
Electric
parts cover
Procedure
1. Detachment
1) Perform work of procedure
1
-1.
2) Take off screws (Ø4 × 10, 3 pcs.) fixing the
electric parts cover.
3) Remove the electric parts cover from the
temporary hanging hook of the electric
parts cover, and then open the cover.
2. Attachment
1) Close the electric parts cover and hook the
cover hole to the temporary hanging hook.
2) Tighten the fixing screws. (Ø4 × 10, 3 pcs.)
Remarks
Screws Temporary hanging hook
Screw
Unnecessary to remove this hook.
1. Detachment
1) Perform work of procedure of
1
-1.
2) Turn clockwise screws (4 positions) at the
suction port corner until adjust corner
cover rises up.
NOTE)
When you work, keep the torque at below 12N•m.
Do not use an electric screwdriver; otherwise the
mechanism of adjust corner cover may be
damaged and not be removed.
3) Pull downward the risen-up part of adjust
corner cover and remove it.
4) Remove the strap of adjust corner cover.
2. Attachment
1) Attach the strap of adjust corner cover to
the panel, hook claws of adjust corner
cover to the panel corner, and then push
the opposite side into the panel.
2) Turn screws (4 positions) of the suction
port corner counterclockwise until bump
between adjust corner cover and panel
disappears.
NOTE)
When you work, keep the torque at below 12N•m.
Do not use an electric screwdriver;
otherwise the mechanism of adjust corner cover
may be damaged and not be removed.
3
Adjust
corner cover