Toshiba CEILING TYPE Air Conditioner User Manual


 
– 11 –
Explanations given to user
If you have discovered that the fan grille is damaged, do not approach the outdoor unit but set the circuit
breaker to the OFF position, and contact a qualified service person to have the repairs done. Do not set the
circuit breaker to the ON position until the repairs are completed.
Relocation
Only a qualified installer (1) or qualified service person (1) is allowed to relocate the air conditioner.
It is dangerous for the air conditioner to be relocated by an unqualified individual since a fire, electric shocks,
injury, water leakage, noise and/or vibration may result.
When carrying out the pump-down work shut down the compressor before disconnecting the refrigerant pipe.
Disconnecting the refrigerant pipe with the service valve left open and the compressor still operating will
cause air, etc. to be sucked in, raising the pressure inside the refrigeration cycle to an abnormally high level,
and possibly resulting in reputing, injury, etc.
(1) Refer to the “Definition of Qualified Installer or Qualified Service Person.”
Declaration of Conformity
Manufacturer: Toshiba Carrier Corporation
336 Tadehara, Fuji-shi, Shizuoka-ken 416-8521 JAPAN
Authorized Nick Ball
Representative/TCF holder: Toshiba EMEA Engineering Director
Toshiba Carrier UK Ltd.
Porsham Close, Belliver Industrial Estate,
PLYMOUTH, Devon, PL6 7DB.
United Kingdom
Hereby declares that the machinery described below:
Generic Denomination: Air Conditioner
Model/type: RAV-SM404MUT-E RAV-SM404MUT-TR
RAV-SM454MUT-E RAV-SM454MUT-TR
RAV-SM564MUT-E RAV-SM564MUT-TR
RAV-SM564BT-E RAV-SM564BT-TR
RAV-SM804BT-E RAV-SM804BT-TR
RAV-SM1104BT-E RAV-SM1104BT-TR
RAV-SM1404BT-E RAV-SM1404BT-TR
RAV-SM564CT-E RAV-SM564CT-TR
RAV-SM804CT-E RAV-SM804CT-TR
RAV-SM1104CT-E RAV-SM1104CT-TR
RAV-SM1404CT-E RAV-SM1404CT-TR
Commercial name: Digital Inverter Series / Super Digital Inverter Series Air Conditioner
Complies with the provisions of the “Machinery” Directive (Directive 2006/42/EC) and the regulations
transposing into national law.
Complies with the provisions of the following harmonized standard:
EN 378-2: 2008 / A1: 2009
Note: This declaration becomes invalid if technical or operational modifications are introduced without the
manufacturer’s consent.