Filter
Top Products
WINDING A BOBBIN
x Place spool of thread onto spool pin.
x Press spool holder ring against spool.
CAUTION: Spool of thread
should be rotated freely after
pressing the holder ring on.
x Lead thread to Guidepost (1) and draw
to the left under pretension stud (2).
x Draw thread between the two tension
discs of thread tension dial, then pull
thread to right as shown.
x Follow arrows. Guide thread through
guidepost (3).
x Open the bobbin winder cover and in-
sert a bobbin.
x Align the small bobbin hole on pin of
bobbin winder.
x Follow arrows. Manually wind thread
clockwise around the bobbin 3-5 turns,
then pass thread through the notch.
x Still holding end of thread, push on/off
switch and start to wind
x Trim the end of the thread after bobbin
is wound around a few times.
(5-10 winds)
x Continue to wind bobbin until desired
amount is reached and cut thread.
CAUTION: Do not over-wind bobbin.
Over-winding causes thread jamming of
bobbin case.
5