Filter
Top Products
5. Pull thread from spool and, using
two hands, pull it through the
diagonal slit in first thread guide
First thread guide should look like
this when properly threaded.
6. Wrap thread one time
counterclockwise around
tension disc.
7. Feed end of thread through small
hole in top of bobbin from the
inside, leaving a 3” tail.
8. Slide power switch into “1” (On)
position.
Hold the end of the thread (the
“tail”) firmly and step on foot pedal
until a few coils are wound onto
bobbin and stop.
9. Use the thread trimmer to cut off
tail, so it is flush with the top of
the bobbin. Continue winding
until the desired amount of thread
is wound onto bobbin. A full
bobbin holds 35 yards.
10. Cuts thread about 4” from the
bobbin and remove it from the
machine. Leave the spool of
thread on spool pin on back of
machine. Push bobbin winder
switch up into “Off” position.
8