Filter
Top Products
RAISING THE BOBBIN THREAD
1. Hold top (needle) thread and turn
hand wheel toward you until
needle goes to its lowest and then
its highest point.
Raise the presser foot using the
presser bar lifter.
2. Gently pull top (needle) thread
until lower (bobbin) thread comes
up in the form of a loop.
3. Use the flat side of seam
ripper/thread trimmer to open up
bobbin thread loop until end is
visible.
4. Pull both thread tails straight back
under presser foot.
5. Replace see-though bobbin cover
by sliding it back into place.
You are now ready to sew!
12