Filter
Top Products
10
THREADING THE MACHINE
There are six thread guides that the
top thread passes through. The
diagram at right shows an overview of
the threading procedure; refer to the
specific instructions below for
important details.
Your spool of thread should be in the
same position as it was for winding
the bobbin- on the spool pin on the
back of the machine. Cut the thread
near the spool and pull the tail out of
the thread guide and tension disc.
1. Pull thread from spool, (using two
hands); pull it through diagonal slit
in thread guide “A”. Do not wrap
thread around tension disc for
sewing.
Thread guide “A” should look like
this when properly threaded.
2. Hold thread firmly against top of
machine between thread guides
“A” and “B” and pull down in
between two silver discs.
3. Feed the thread under disc thread
guide “C” and through opening
created by guide bar.
Insert thread from right to left.
Leave some slack in the thread to
the right.