Filter
Top Products
7
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
ledoM
.oN
AB C D EF
005-D
005-TD
005-RD
.ni8/1532/1758/50461/3914/3828/16
mm29816412301784037651
006-D
006-TD
006-RD
.ni8/10461/31623/13461/39161/11038/77
mm910145511011784977002
008-D
008-TD
008-RD
.ni8/1548/36661/516461/39161/3334/39
mm641168612911784348842
C
Back wall of chase/enclosure
(including any finishing materials)
a
7 (178)
b
Note-
Venting requirements for rear vent applications in corner
installations -
- the the round termination (SV4.5HTR) may not be used
- the horizontal vent length “a” to “b,” must not exceed 28
inches (711 mm)
Inches
(millimeters)
*These dimensions occur when one 45
degree elbow is connected directly to the
appliance collar.
D and DR units
D and DT units
*D
E
*F
A
B
.oNledoMABCD
005-D
.ni4/1534/15361/11128/193
mm598598155499
005-TD
.ni4/1534/153----8/193
mm598598----499
005-RD
.ni4/1534/15361/1112----
mm598598155----
006-D
.ni4/1044/10461/11628/144
mm220122018761211
006-TD
.ni4/1044/104----8/144
mm22012201----1211
006-RD
.ni4/1044/10461/1162----
mm22012201876----
008-D
.ni4/1544/10461/11628/144
mm941122018761211
008-TD
.ni4/1544/104----8/144
mm94112201----1211
008-RD
.ni4/1544/10461/1162----
mm94112201876----
A
B
D
7
(178)
5¹⁄₈
12¹⁄₈
(308)
10¹⁄₂
(267)
C
VENT FRAMING -
TOP VENT WITH ONE
90° ELBOW
VENT FRAMING -
REAR VENT WITH
NO ELBOWS
Framing should be constructed
of 2x4 or larger lumber.
Inches (mm)
(130)
5¹⁄₈
(130)
7
(178)
16” (406mm) is the required framing depth dimension when
the finish material (drywall) thickness is 1/2 in. (13mm).
¹⁄₂ A
**FRAMING WITH SQUARE HORIZONTAL TERMINATIONS (SV4.5HTSS or SV4.5HTS)
AND ROUND HORIZONTAL TERMINATION (SV4.5HTR)
** See the horizontal venting Figures 33 and 34 on page 16 for restrictions on the use of the
round termination (SV4.5HTR).
12¹⁄₈
(308)
16
(406)
Figure 9
Figure 10
Corner Framing with Square Termination (SV4.5HTS)
Framing Dimensions
FIREPLACE FRAMING SPECIFICATIONS