Filter
Top Products
Blo wer ”re ge ne ra ti on hea ter” / Blo wer ”dry ing hea ter”
Re mo ve the pro tec ti ve grid of the blo wer (po si ti on 3).
Loo sen the nut (po si ti on 1).
Loo sen and re mo ve the screw (po si ti on 2).
Sli de mo tor with car rier flan ge pla te (po si ti on 6) to wards the car rier flan ge hou sing (po si ti on 4).
Re mo ve de fec ti ve V-belts (po si ti on 5), put on new ones.
F
At ten ti on should be gi ven to ex act alignment of the V-belt pul leys.
Ad just belt ten si on by screw (po si ti on 2) in ac cor dan ce with the in for ma ti on sti cker.
Tighten the nuts on threa ded bolt (po si ti on 1) again.
Mount the pro tec ti ve grid of the blo wer (po si ti on 2).
Mount the side pa nels.
026-2MS
STT 500
Main ten an ce 5-9