Filter
Top Products
3.5.3. Entering hopper values
Select ”Hopper”.
Acknowledge with the ENTER-key.
or
Press the ”F4”-key.
Hopper entry X Target
(X = number of the drying hopper)
Enter the drying temperature for hopper flap X (when operating with supplementary heating).
Acknowledge with the ENTER-key.
Hopper entry X Act.
(X = number of the drying hopper)
The current temperature at the feed opening of hopper flap X will be displayed.
&
If there is a ca ble break “+0 °C” (32°F) is dis played.
F
The lowest drying temperature setting of the hopper flap must be the
same as or higher than the drying temperature.
Press the “â” key.
026-2MS
STT 500
Start-up 3-11