Filter
Top Products
XG200 Elliptical
6
1. The computer cable is pre-installed to the console mast and main frame so be careful not to pull
too hard on the console mast during assembly to avoid
damaging them.
2. Connect cable (100) to (101).
3. Place the console mast onto the mating plate of the main frame; Be careful not to pinch the
speed sensor wire between the console mast and the main frame plates during assembly.
4. Secure the console mast in place with the four stainless steel bolts (42) and split washers (50).
Make sure the bolts are securely tightened using the 8mm Allen wrench (108).
5. Attach the hand brake lever (90) to the handlebars as follows:
CONSOLE MAST
1
#42. M10 x 20mm
Stainless Steel Bolt
(4 pcs)
#50. M10
Split Washer
(4 pcs)
HARDWARE
Remove the screw that is threaded into the nut on the backside of the hand brake with the
Phillips head screw driver (107)
Place the hand brake bracket around the front of the right handlebar vertical tube, then
insert the bolt through the back of the bracket and thread back into the nut. Tighten with the
Phillips head screw driver (107)
Loosen the two cable retainer brackets on the back of the console mast with the Phillips
head screw driver (107) just enough to allow the cable to nest behind them. Retighten the
screws after placing the cable behind them.