Filter
Top Products
XE195 / XE295 Elliptical
8
5. With the 13/14mm Wrench tighten the three bolts, and the fourth bolt which is pre-installed,
firmly. These bolts should be tightened as much as you possibly can.
6. There will be three electrical wire connectors at the top opening of the console mast, two 2 pin
connectors for hand pulse sensors (36), one 10 pin connector for main wire harness (31) and
one connector for the handle bar resistance switches (145). Connect these to the mating
connectors on the back of the electronic Console (30). The connectors are keyed, you cannot
plug them in the wrong way so do not force them. The two, 2 pin connectors can be plugged
into either connector on the back of the console.
7. Storing the excess wire back into the Console Mast, carefully install the Console onto the
mounting plate of Console Mast and secure using the four M5 x 10mm Phillips Head Screws
(66).
Make sure the wires do not get pinched between the console and mounting plate.
STEP 2: HANDLE BAR ASSEMBLY
1. Install the two 17mm Wave Washers (83) onto the Left and Right side of the Handle Bar axle.
2. Slide the Left (10) and Right (11) Handle Bars onto the appropriate side of the axle. The
handlebars have a small sticker on them indicating
L
(left) and
R
(right).
3. Put the two 5/16" x 23mm Flat Washers (79) onto the two 5/16" x 15mm Hex Head Bolts (59)
and install in the threaded holes in the ends of the axle.