Filter
Top Products
37X Speed Dome Camera 14/50
Installation with Wall Mount Bracket
① Make a hole whose diameter is 30~40mm
on the mounting surface to pass the
wire(s) and cable(s) through the mounting
surface. (In case of the wiring and cabling
through the mounting surface only) Then
prepare the wall mount bracket. Pull the
wire(s) and cable(s) for the system as
below. Attach the wall mount bracket to
the mounting surface. (Hex Lag #14×50)
② Hook up “Drop Prevention Spring” on
main body to prevent camera from
unexpected drop and pull the wire(s) and
cable(s) for the system as below.
③ Line up the mold lines and assemble
main body to mount adaptor and turn it.
And assemble the main both with the
camera mount adaptor with the 3 screws.
(Machine M5×15).
④ Screw the dome cover to the main body
and remove the protection vinyl from the
dome cover.
Important Notice
z Before starting the installation, make sure that the Camera ID and Protocol are set up properly.
INSTALLATION 2