Filter
Top Products
OPERATION (CONT.)
ADJUSTING THE AIR FLOW DIRECTION
1. Rotating the unit - if the unit has been installed with a single lag bolt, simply rotate the entire unit
as needed to adjust the direction of the air flow.
2. Tilting the unit - Loosen the bracket screws, tilt the heater to the desired position, and re-tighten
the bracket screws. NOTE: To tilt the heater it must be mounted in bottom keyhole slots of
mounting brackets to maintain adequate clearance and prevent possible overheating.
3. Adjust the louvers to the desired position. NOTE: The louvers are designed so they cannot be
completely closed. Do not attempt to close the louvers completely as this may damage the unit.
.
To prevent possible electric shock, disconnect the power to the heater at the main service box be-
fore attempting to adjust the heat output of the unit.
9
www.sylvane.com 1-800-934-9194