Filter
Top Products
LOCATION AND INSTALLATION (CONT.)
CONNECTING THE POWER
1. Turn off the power at the main service
2. Remove the screw from the back of the unit to connect the power to the heater.
3. Attach the cable connectors to the unit and slide the 10 gauge wire through the cable connector.
NOTE: For certain applications, conduit may be required. Check your local electrical codes. If
you run the wiring in conduit and wish to be able to rotate the heater, be sure to purchase
enough flexible conduit to allow the heater to be rotated.
4. Connect the wire to the power terminal block located in the base of the heater.
5. Turn on the power at the main service.
8
OPERATION
NOTE: The first time you operate this heater, it may emit a slight odor and some smoke. This is due
to the residual cleaning agents used to clean the element during manufacturing. This is normal op-
eration and will cease after the heater has been used for a few minutes.
www.sylvane.com 1-800-934-9194