Filter
Top Products
LOCATION AND INSTALLATION (CONT.)
MOUNTING THE BRACKET
1. Locate a stud in the ceiling joist.
2. Remove the mounting bracket from the heating unit be loosening the bracket screws with a
wrench and slipping the handle off over the screw heads.
3. Place a washer on the screws before inserting through the holes in the mounting bracket and
screw them securely into the ceiling joist. NOTE: If you want the heater to swivel side to side,
add a washer to both sides of the bracket. A longer lag bolt may be required to properly secure
the unit.
4. Tighten the screw enough to securely hold the heater with the airflow pointed in the proper direc-
tion.
7
HANGING THE HEATER
1. Lift the heater up and into the mounting bracket.
2. Align the bracket screws with the keyhole slots in the mounting brackets
3. If the heater is to be tilted, it must be positioned in the keyhole slots.
4. Tighten the bracket screws with a wrench so the unit is securely suspended at the desired hori-
zontal or vertical level.
SINGLE –SCREW MOUNTING DOUBLE –SCREW MOUNTING
www.sylvane.com 1-800-934-9194