Filter
Top Products
OPERATION
1. Plug the power cord into a grounded outlet
•
After the power cord is plugged into an outlet, the power light will turn on.
• The fan will continuously run, even if the compressor shuts off.
2. Open the louver manually
• Before operation starts, please check and make sure the louver has been opened. If the louver is
closed, the unit may overheat.
• Set the louver to the preferred angle from the 6 options. (When the indoor temperature is above
91°F, set the louver to the maximum opening).
3. Button operation modes
• Press the POWER button once. The unit will operate in continuous mode automatically. Press the
HUMIDITY LEVEL button to select a room humidity level of 50%, 60%, or 70%.
• Power Level: Press POWER LEVEL button to choose the desired power level.
• When the indoor temperature is below 59°F or above 95°F, the protection device is activated.
The unit can only operate in HIGH power and the POWER LEVEL button is ineffective.
4. Stop operation
• Press the POWER button to stop dehumidification.
• Never stop the unit by unplugging the power cord.
DRAINING THE COLLECTED WATER
When the drainage tank is full, the tank full indicator light will turn on to alert the user and operation will
stop automatically. The water then needs to be emptied from the drainage tank.
Emptying the Drainage Tank
1. Lightly press on the sides of
the tank with both hands and
pull out gently.
2. Grasp the handle and pull out
the tank completely out.
3. Discard the collected water.
8