Filter
Top Products
–
7
–
INSTALLATION
3. Thread the AC adapter cord through the top
hole in the back of the unit and plug it into
the AC connector on the circuit board as
shown. The adapter cord must be inserted
through the back of the unit beforeit is
attached to the wall.
4. Insert the 9 volt battery and rotate the
antenna from the inside of the dialer to
the outside.
5. Firmly close the case. Insert and secure the
two screws to the bottom case near the two
tabs.
6. Using the template provided, insert the two
screws into the wall.
7. Gently hang the Dial-Alert to these two
screws.
8. Plug the other end of the telephone cord into
a telephone jack. Plug the AC adapter into a
power outlet. The red AC PWR light will turn
on and the keypad backlight will flash.
CAUTION: After installation, please use two
screws (included) to fix the front and back case
together before hang on to the wall. (When you
open the case, please remove the AC adapter
and the phone line from the wall outlet).
2. Thread the telephone line through the top
hole in the back of the unit and plug it into
the "LINE" jack. If you want to have an
answering machine on the same line as
the dialer, thread the phone line through the
bottom hole in the back of the unit and plug
it into the "PHONE" jack of the dialer. The
phone line(s) must be inserted through
the back of the unit before it is attached
to the wall.
–
8
–
INSTALLATION
Switch Setting
1. Tone/Pulse Switch
This dialer supports both Tone and Pulse
dialing. In order to change the setting, you
need to open the case by pressing the two
tabs on top of the dialer and pull open the front.
The Tone/Pulse switch is located at the upper
left corner of the circuit board (just above
the adapter jack). The switch is set to Tone at
the factory. This setting can be changed by
sliding the switch to the appropriate position.
2. Speaker On/Off Switch
The speaker must be on during programming
and recording the voice message in order to
use the playback feature. For security pur-
poses, the speaker may be turned off after
programming to allow for silent dialing when
the dialer is activated.
The On/Off switch for the speaker is located
on the lower right corner of the circuit board.
The default setting for the speaker is "On".