SkyLink Emergency Dialer Dial-Alert Home Security System User Manual


 
23
The AD-433S Dial-Alert comes with 1 battery that at some point you may have
to replace:
One 9 volt alkaline battery for the Dial-Alert
Recommendation: Test your Dial-Alert periodically to ensure that the battery
is working.
Dial-Alert Battery
The Dial-Alert comes equipped with a 9V backup battery in case the elec-
trical power is interrupted for any reason.
When the dialer backup battery is low, the LOBATT. light goes on.
To replace the dialer backup battery:
1. Undo the two screws on the back of the
Dial-Alert.
2. Open the Dial-Alert case by pressing
down on the two tabs on the top edge
and pull the front forward.
3. Disconnect the old battery.
4. Connect the new battery.
5. Close the Dial-Alert case and re-insert the
two screws.
The battery life, (9 volt alkaline battery), is approximately two years if used
only for backup.
Note: If the AC adapter is disconnected while the battery is being replaced,
the pre-recorded message will be erased, and the clock will return to 12:00.
Re-record the emergency voice message and reset the clock. (Refer to page 10).
The pre-programmed phone numbers will not be erased even the power is
disconnected.
BATTERY MAINTENANCE
24
ADDITIONAL ACCESSORIES
Motion Sensor (PS-433A)
- Monitors area in a 110 degree ARC and up to
40 feet away from the sensor
- 9V alkaline battery included
Door/Window Sensor (WT-433)
- Attaches to all doors, windows, entrances
- Add on as many magnetic switch (MS-001) as
needed
- 12V alkaline battery included
Magnetic Switch/Magnet (MS-001)
- Used in conjunction with Door/Window Sensor
(WT-433)
- Add on for additional doors, windows
Keychain Transmitter (4B-434)
- Activates Security Control Panel (SC-001) instantly
by pressing panic button
- Arm/Disarm Security Control Panel (SC-001)
- Reliable design, crystal base transmission with
microcontroller
- 12V alkaline battery included
Audio Alarm (AA-433)
- Additional indoor/outdoor siren
- Water resistant
- 120 dB siren with flashing LED
- Operates by AC adapter with 9V alkaline
back up battery (included)
Additional sensors and transmitters as well as add on accessories are available
to work with your Dial-Alert.