Singer 82387 Sewing Machine User Manual


 
Table of Contents Previous Page | Next Page
14
82387 No. 66
To Oil the Machine continued...
At the back of the machine is a round plate or
cover, fastened by a thumb screw; loosen the
screw, turn the plate upward and fasten by
tightening the screw; turn the balance wheel
slowly and oil the moving parts inside then
turn the cover down and fasten it as before.
To reach the parts underneath the bed the
belt must be thrown off the band wheel on
the machine stand. For this purpose the belt
shifter (F. Fig. 1, page 1) is placed at the front
of the band wheel. By pressing the belt shifter
lever to the left and working the treadle
meanwhile, the belt is released and the
machine can then be turned back on its
hinges. The places to be oiled are indicated
in Fig. 18, page 17, by arrows pointing to the
oil holes and bearings.
To oil the stand, put a drop of oil on each of
the places shown by arrows in the above
illustration (Fig. 19).
FIG. 18. OILING POINTS IN BASE OF MACHINE
FIG. 19. POINTS IN STAND