Singer 82387 Sewing Machine User Manual


 
Table of Contents Previous Page | Next Page
13
82387 No. 66
To Oil the Machine
To ensure easy running the machine and
stand requires oiling and if used continuously
it should be oiled each day. With moderate
use an occasional oiling is sufficient. Oil
should be applied at each of the places
shown by arrows in Figs. 17, 18 and 19. One
drop of oil at each point is sufficient. Oil holes
are provided in the machine for bearings
which cannot be directly reached.
To oil the mechanism under the slide, draw
the slide (see Fig. 17) to the left and after
removing the lint and dust which may have
accumulated put a few drops of oil on the
small piece of felt at the right of the bobbin
ejector. The slide should then be closed.
Take out the thumb screw (A, Fig. 17) near
the lower end of the face plate, raise the
plate and slip it off over the head of the screw
near the upper end of the plate; put one drop
of oil into each of the oil holes and joints.
FIG. 17. FRONT VIEW, SHOWING OILING POINTS