Filter
Top Products
This is a simple operation but it is important to carry out
correctly as by not doing so several sewing problems could
result.
- Start by raising the needle to its highest point (1), and
also raise the presser foot to release the tension discs. (2)
Note: For safety, it is strongly suggested you turn off the
power before threading.
- Lift up the spool pin. Place the spool of thread on the
holder with the thread coming off the spool as shown. For
small thread spools, place small side of spool holder next
to spool. (3)
- Draw thread from spool through the upper thread guide. (4)
- Guide thread around thread guide (5) pulling thread
through pre-tension spring as illustrated.
- Thread tension module by leading thread down right channel
and up left channel (6). During this process it is helpful to
hold the thread between the spool and thread guide (4).
- At the top of this movement pass thread from right to left
through the slotted eye of the take-up lever and then
downwards again. (7)
- Pass thread behind the flat, horizontal thread guide. (8)
- Now take thread behind the thin wire needle clamp guide
and then down to the needle which should be threaded
from front to back. Pull about 6-8 inches of thread to the
rear beyond the needle eye. (9)
If your sewing machine is equipped with the factory
installed optional automatic needle threader, instructions
for use can be found on page 26.
Note:
24
Threading the upper thread
GB
6
7 8 9
3 4 5
1
2
3
4
5
6
7
8
9