Filter
Top Products
10
4830 & 4832
Attaching the feed cover (F)
The feed cover is used to keep the feed from
moving the fabric when attaching a button,
darning or sewing free motion embroidery. To
attach it, follow the directions below:
• Raise needle and presser foot.
• Open slide plate.
• Slide feed cover on top of needle plate,
pressing tabs (1) and (2) into holes.
• Close slide plate.
• To remove open slide plate and lift front
edge of cover; pull it away.
Changing snap-on presser feet
(B),(D),(J),(L)
• Raise needle to its highest position by turn-
ing hand wheel toward you.
• Raise presser foot using presser foot lifter
at back of machine.
• Push to of presser foot (1) up, until it snaps
off the shank (2).
• Remove foot from machine.
• Place new foot under centre of shank.
• Lower presser foot lifter, fitting shank over
presser foot pin (3).
• Don't turn screw. Instead, push presser foot
screw (4) down, firmly until foot snaps into
place.