Filter
Top Products
Operating Procedures / Photos
Screw off the screw, then press the clasps in by
till they loose, then lift up wards the electric cover
.
4. Disassemble the electric cover
5.
Disassemble water tray
Electric cover
5. Disassemble the electric box
Screw off the grounding wire of the evaporator,
remove the
temperature sensor for the pipe, put
ou
t the connection lines for the step motor and
the indoor motor. Screw off the screw fixing the
electric
box. Remove the electric box.
Grounding wire
Connect
or
Tube Sensor
Clasp
Clasp
Water tray
Screw
Clasp
Screw
Loosen the clasps at both sides of water tray sub-assy then lift them up,
can take out of the water tray sub-assy.
Note:Because the water tray is connected with the water drainage pipe,
so when take it out should pay more attention, avoid to hurt the fin of
evaporator.