Filter
Top Products
13
Installation
Low Voltage Connections
Connect the low voltage wires to the low voltage inlet on your unit.
To do so:
1. Strip wires over 1 cm (1/2 inch) (figure 10).
2. Gently press on the toggle to open the connector (figure 11).
3. Insert stripped wire (figure 12).
4. Release toggle to secure wire in connector (figure 13).
5. Repeat for second wire.
To disconnect:
1. Gently press on the toggle to open the connector.
2. Remove low voltage wire from connector.
gure 11gure 10
gure 12 gure 13
LED
Except H60 &
H110 models
details on
page 15