Filter
Top Products
Step 2.
Remove the fence and apply a strip of masking
tape along the the rail
3
⁄16'' in from the front edge.
Step 3.
Using the zero mark as the starting point and the
masking tape as a guide, apply the adhesive scale
to the rail. Figure 23. Burnish the scale into place
with heavy thumb pressure.
-16- Shop Fox
®
Fence
Figure 22. Placement of the scale.
Figure 23. Attaching the scale.
G. SCALE/INDICATOR
The self adhesive scale (#56) and hairline indica-
tor (#40) provide fast and accurate fence position-
ing. To mount the scale and indicator, proceed as
follows:
Step 1.
Locate the zero point of the scale by measuring 2''
to the left of the blade and mark the rail. Figure
22.
Step 3.
Continue to rotate the axle until the fence is square
to the table. Tighten the setscrew.
Step 4.
It is advisable at this point to recheck parallel-
ism between the fence and the blade. If further
adjustment is required, continue to check back
and forth between parallelism and squareness
until both are adjusted satisfactorily. Remember
to adjust with the setscrews loose and measure
with the setscrews tight. This procedure may
seem a bit tedious, but this is a one time adjust-
ment that, if done patiently, will ensure excellent
performance.
Figure 21. Adjusting the left roller axle.
Rotate nut to rotate axle