Filter
Top Products
ENGLISH
E-15
2
Remove the Humidifying filter from the
Humidifying Tray. Drain accumulated wa-
ter by tilting the Humidifying Tray slowly.
1
Remove the Water Tank and Humidifying
Tray.
Frequency of maintenance cycle will depend on the hardness
of the water. Avoid spilling water when removing or cleaning
the tray.
3
Rinse the inside of the Humidifying
Tray with lukewarm water to remove
impurities.
• Do not remove the Styrofoam fl oat.
• Clean diffi cult-to-reach parts with a cotton-
tipped swab or tooth brush.
CAUTION
If the Styrofoam fl oat comes off,
replace by inserting the tabs of
the Float into the holes in the
Humidifying Tray as shown in the
diagram.
When Water Deposits are Diffi cult to Remove
• Use only mild kitchen detergents to
clean the Humidifying Tray. Use of
non-designated chemicals or deter-
gents can cause deformation, tar-
nishing, cracking (water leakage).
Insert the fl oat below
this tab.
Insert the tab on
the other side of the
fl oat into the hole.
Insert the tab of the
fl oat into the hole.
1
Fill Humidifying Tray half-
way with lukewarm water,
add a small amount of mild
kitchen detergent, and leave
to soak for about 30 min-
utes.
Dilute detergent according to
instructions on the container.
Clean diffi cult-to-reach parts
with a cotton swab or tooth
brush.
2
Rinse the Humidifying
Tray with lukewarm wa-
ter.
• Rinse until all detergent residue
is removed.
• Inadequate rinsing may cause
the detergent odor or changes in
the shape/color of the main unit.
HUMIDIFYING TRAY
Care Cycle
1 month
Unlatch the Water
Tank first, then re-
move the tray. Use
both hands when
pulling out the Hu-
midifying Tray to
avoid spilling water.
Humidifying fi lter
Humidifying Tray