Filter
Top Products
PREPARATION
Be sure to remove the power plug from the wall outlet.
INSTALLING THE FILTERS
To maintain the quality of the filters, they are installed in the main unit within polyvinyl bags.
Be sure to remove the filters from the polyvinyl bags before using the unit.
1
Remove the filters
1
Place the unit facing up
Place the unit on a table, etc., so that the
stand does not touch the surface.
2
Remove the front panel
Press in the hook on the bottom of the front
panel and lift to remove.
3
Remove the pre-filter, and
then remove the stamina-
power carbon (black) and
HEPA filter (white) that are
inside the polyvinyl bags.
INSERTING BATTERIES IN THE REMOTE CONTROL
1
Remove the
back cover
Press and slide the
back cover to re-
move.
2
Insert batteries
Insert batteries with
and as shown
below.
3
Close the back
cover
About the batteries
• The battery life is about 1 year.
Replace the batteries when the remote con-
trol becomes inoperative.
• Incorrect usage of the batteries may cause
battery fluid leakage and/or damage. Take
caution of the following when handling:
•When replacing the batteries, replace
both batteries with new ones of the same
type. (Use AA alkaline batteries (2 units)
or AA manganese batteries (2 units).)
• When not using the unit or remote con-
trol for an extensive period, remove the
batteries. This prevents malfunction of the
remote control from battery fluid leakage.
Soft cloth
Prefilter
Table, etc.
Front panel
1
1
2
2
1
Place so stand
does not touch
the surface
Hook
Stamina-power carbon
E-8