Filter
Top Products
DEHUMIDIFICATION MODE
E-10
7
6
In this mode, the air conditioner dehumidifies the room.
Drainage nozzle
Stopcock
Hose clamp
Hose
1
Remove the exhaust hose (See Page 8)
2
Turn the drainage nozzle to the OPEN
position.
3
Pull the stopcock out from the drainage
nozzle.
• When the stopcock is removed, a small amount
of water may be discharged from the drainage
nozzle.
• Always perform this procedure with the unit
turned off. Drain water will spout out if
attempted during operation.
4
Insert the hose clamp into a standard
commercially-available hose (12.7 mm in-
ner diameter, 16.7 mm outer diameter)
5
Attach the hose to the drainage nozzle,
and secure it with the hose clamp.
• Depending on room condition, approximately
28 liters of water per day (24 hours) will be
dehumidified.
Prepare some kind of bucket of appropriate
size to collect drain water, or take some appro-
priate measure to drain the water outside of the
room, so that drain water will not overflow or
soak your room.
• Set the hose sloping downwards for easier
drainage. Moreover, do not bend the hose at
any point, nor allow the end to be submerged
in water.
6
Press the MODE button to select DEHU-
MIDIFICATION mode.
COOL DEHUM FAN VENT
7
Press the ON/OFF button to start opera-
tion.
• The red OPERATION lamp ( )on the unit will
light.
• The temperature cannot be set.
• The fan speed is preset to AUTO and cannot
be changed.
TO TURN OFF
Press the ON/OFF button again.
• The red OPERATION lamp ( )on the unit will turn
off.
CAUTION
The unit generates heat during dehumidification mode and the room temperature will rise.
Install the exhaust hose if you do not want the room temperature to rise. This will help to
slightly drop the room temperature, but dehumidification performance will become less
effective than when operating without the exhaust hose.
“OPEN position”