Filter
Top Products
9. HEPA Filter Cover
10. Front Panel
11. Full Bag Indicator
12. On/Off Switch
13. Lock Plate
14. Motorized Power Head
15. Handle Release
16. Head Light
1. Upper Handle
2. Flexible Hose
3. Main Body
4. Dusting Brush
5. Hose Connector
6. Crevice Nozzle
7. Nested Extension Tubes (2)
8. Carpet Height Adjustment Knob
Upright Vacuum
Deluxe
5. Changing the Power Nozzle Belt:
A) Occasionally the power nozzle drive belt will require changing, the
frequency will depend upon the amount of use your vacuum sees.
B) Turn unit “Off” and unplug from wall outlet.
C) Use a Phillips screwdriver and remove the two screws from the
back of the motorized power head cover.
D) Remove the two screws from the bottom of the motorized power
head.
E) If the belt has broken, remove any loose pieces before replacing.
F) Grasp the beater bar at either end and lift straight up.
G) Place one end of new belt over motor shaft and the other on the
round pulley end of the beater bar.
H) Align the rubber supports at the ends of the beater bar, with the slots
in the motorized power head. Push into place. Ensure that the cut-
outs on the rubber supports face upwards.
I) Replace the two screws from the bottom of the motorized power
head and then replace the cover. Then replace the two screws from
the back side of the motorized power head.
6. Changing the Head Light Bulbs:
Warning
: Always disconnect from power source when servicing or
cleaning the unit. Failure to do so could result in electrical shock or
personal injury from cleaner suddenly starting.
1. Turn unit “Off” and unplug from wall outlet.
2. With a Phillips #2 screw driver, remove the two screws that are on the head
light lens.
3. Lift off the head light lens.
4. Remove the light bulbs by pulling them out carefully.
5. Replace the new bulbs by pushing them in.
6. Replace the head light lens and then replace the two screws on the
head light lens to secure in place.
Note: Always replace the light bulb with the same or smaller wattage size
(12V 4W) to prevent damage to the surrounding parts.
Technical Specifications
Voltage: 120V., 60Hz.
Power: 12 Amps
1 6