Shark UV204 Vacuum Cleaner User Manual


 
3. Changing & Cleaning the Pre-Motor Filter:
A) This is best done every three months or depending on the amount
of usage.
B) Remove the front panel of the vacuum cleaner.
C) To remove the pre-motor filter, simply slide it out.
D) To clean the filter rinse in warm, soapy water. Filter must
by completely dry before re-installing into your vacuum.
E) Once filter has been replaced, replace front panel.
Assembling Your Vacuum Cleaner
Warning: Do not plug in vacuum unit until it is fully assembled.
1. Carefully unpack all components,
set aside packaging.
2. Lift vacuum body to upright position.
3. Remove the screws (2) that are already
attached to the body.
4. From the rear of the vacuum, align the handle
with groove