Filter
Top Products
OPERATING INSTRUCTIONS
MESURES DE PRÉCAUTION
Wash
once a
month or
when
suction
appears
reduced
Fig. A
Changing & Cleaning the Pre-
Motor Filter
The pre-motor filter is a washable filter
but should be replaced every three (3)
months.
• Remove the dust cup container, the
Non-Woven Pre- Filter and the HEPA
filter to remove the pre-motor filter.
(Fig 14)
• Rinse the pre-motor filter in lukewarm
water and air dry the filter completely
for 24 hours. Do not use a washing
machine to rinse the filter.
Do not use a hair dryer to dry it. Air
dry only. Never operate the vacuum
without the pre-motor filter in place.
• When the filter is dry, replace into the
unit and replace the HEPA filter and
dust cup container.
• A severely soiled or clogged filter
should be thoroughly washed with
fresh tepid water. A mild detergent
can be used if required.
Pre-Motor
Filter
PLEASE NOTE: The white pleated
filter material in the HEPA Filter will
discolor over time -This is NORMAL
and will NOT affect the performance
of the filter. If the HEPA Filter
is properly
"Tap Cleaned”
after each use
and suction
does not return
to 100%, then
we suggest that
the HEPA filter
be “Tap Cleaned”
vigorously until
no more dust
can be removed,
then rinsed
under the faucet and allowed to dry
for 24 hours before refitting into the
vacuum. (Fig. A) This should be
done once a month or when
suction appears to be reduced .
Warning: Allow 24
hours for drying before
replacing in unit.
CAUTION: The suction hole must
be open, free of any obstructions at
all times. Otherwise, the motor will
overheat and could become
damaged.
Fig. 14
Important: Si l’orifice de succion ou le boyau de l’aspirateur est BLOQUÉ, arrêtez
l’aspirateur et retirez l’obstruction avant de l’utiliser de nouveau.
4. Pour débrancher la fiche de la prise
murale, tirez sur la fiche plutôt que
sur le cordon.
1. Ne pas utiliser l’aspirateur près des
chaufferettes, radiateurs ou mégots
de cigarette.
5. Évitez d’utiliser l’aspirateur pour
aspirer toute matière fumante ou
brûlante comme des cigarettes,
allumettes ou cendres chaudes.
2. Avant d’insérer la fiche dans une
prise murale, assurez-vous que vos
mains sont bien sèches.
6. Ne pas utiliser l’aspirateur sans que
TOUS les filtres soit en place.
3. Avant de commencer le nettoyage,
assurez-vous d’enlever tout objet de
grande taille ou pointu risquant
d’endommager l’écran à débris de la
coupelle.
8
Please Note: The HEPA Filter is
washable. It should, however, be
replaced every three (3) to six (6)
months to ensure peak performance of
your vacuum.
The non-woven pre-filter, pre-motor and
post motor filters are washable. They
should however be replaced every
three (3) months to ensure peak
performance of your vacuum.
Important
: Make sure that ALL filters
have completely air dried before re-
installing back in the vacuum.
Never over fill the dust cup container -
remove dirt and clean the HEPA filter,
non-woven pre-filter and debris screen
when dirt in dust cup is at or below the
"MAX" level during prolonged usage
or risk motor damage.
If you wash the Hepa filter or the
non-woven pre-filter, make sure that
they have completely air dried
before inserting back in the
vacuum.
WARNING: Always empty the
dust cup container and clean the
HEPA filter, Non-Woven Pre-Filter
and Debris Screen before each
use and during prolonged usage.
Fig. 15
Changing & Cleaning the Post
Motor Filter
The post motor filter is a washable filter
but should be replaced every three (3)
months.
• Remove the filter cover from the front
of the unit and remove the filter.
(Fig. 15)
• Rinse the post motor filter in lukewarm
water and air dry the filter completely
for 24 hours. Do not use a washing
machine to rinse the filter. Do not
use a hair dryer to dry it. Air dry only.
Never operate the vacuum without the
post motor filter in place.
• When the filter
is dry, replace
into the filter cover
and replace the filter
cover to the unit.
• A severely
soiled or
clogged filter
should be
thoroughly
washed with fresh tepid water. A mild
detergent can be used if required.
25