Filter
Top Products
Page 9
PROBLEM
Does not turn on
Red light is on &
machine shuts off
Red and green lights are
both on
No lights are illuminated
Does not pick up
REASON
1. Te lescopic tube not inserted properly.
2. Not plugged into good outlet.
3. Cable worn.
4. The power control slider switch is
set to “0” (“off” position).
1. Brush roller is jammed.
2. Airflow pathway is clogged.
3. Overload shut down from
excessively deep but loose carpet
pile (e.g., long shag carpet).
1. Brush worn.
2. Reduced brush action.
1. Machine is in upright locked
position and roller is shut off.
1. Telescopic tube tube not
inserted properly.
SOLUTION
1. See page 5.
2. Use another outlet.
3. Replace cable.
4. Slide the power control slider
switch to “on” position.
1. Remove brush roller obstruction.
See page 8.
2. Remove clog. See page 8.
3. If carpet pile is too deep and loose,
then use a “shag rake” attachment
instead of the ET-C power head.
1. Replace brush strip. See page 8.
2. Brush is not fully in contact with
the floor.
1. Release the foot pedal and lower
the telescopic tube to operating
level. See page 6.
1. See page 5.
Trouble-Shooting Guide
Always unplug vacuum from outlet before dismantling any part of the machine!
!
Check your C3.1 or K3 canister user’s manual for more trouble-shooting problems and solutions.