Filter
Top Products
Page 4
SPECIAL SEBO PRODUCT FEATURES
BRUSH CONTROL Lights
Red light
Green light
Quick-reference panel tells you what the
illuminated brush control lights indicate
(see page 7).
The control panel is located on the top side of the power head.
Your SEBO ET-C Power Head is designed specifically for use with the SEBO C3.1 and K3 canister vacuum
cleaners. These vacuums are among the most technically advanced canister vacuum cleaners in the world.
For example, the ET-C Power Head has warning systems and automatic shut-off capabilities that are
designed to alert the user to machine problems that, if ignored, will damage the machine or diminish
performance.
Your SEBO ET-C Power Head’s most unique features are:
1.
Deep Cleaning. SEBO power heads offer deep cleaning of your carpets only a thorough brushing can
give.
2.
Wider L-shaped Head. The wider head allows for optimal cleaning and maneuverability around furniture
and under cabinets, and the extension side of the head cleans and brushes right to the edge.
3.
Brush Strip instead of a Brush Roller. The brush strip for the ET-C slides in and out for fast and easy
replacement.
4.
Brush Information Panel. Located on the top of the power head is a brush information panel with two
lights and a quick-reference area that will tell you what the illuminated lights indicate.
5.
Electronic Overload Protection. If the brush is jammed, the red “BRUSH CONTROL” light will
illuminate and the vacuum will automatically shut off.
6.
Brush Deterioration Warning. The red AND green “BRUSH CONTROL” lights will illuminate (after a
10 second delay) to notify the user that the brush strip is too worn and, therefore, should be replaced.
The lights will remain illuminated until the worn brush strip is replaced, but the machine will continue to
operate in the meantime. Both lights may also illuminate if the brush doesn’t find enough resistance; for
example, when the power head is lifted from the floor or is used on hard floors.
7.
Stationary Use. When the machine has its handle in the upright-locked position, it is designed to
shut off the brush roller. Both brush control lights will be off. An operating power head should not stand
stationary on the floor for inappropriate periods of time.