Filter
Top Products
Page 5
1. Power head
2. Brush information panel
3. Swivel neck
4. Connection plug
5. Foot pedal
6. Brush strip cover
7. Telescopic Tube release button
Identification of Parts
1. Find the connection tab (A) at the base of the telescopic tube (B).
2. Move the connection tab (A) IN toward the tube (C). See
enlarged detail below. It will only move approximately 1/8-inch.
Proceed to step 3.
3. Insert the base of the telescopic tube (E) into the power head
swivel neck (3). Make sure that the connection tab (A) is prop-
erly aligned with the connection plug (4) in the swivel neck.
Damage to the connection may occur if the tab and the plug
are not properly aligned.
Attaching the Power Head to
the Telescopic Tube of your
SEBO C3.1 or K3 Vacuum
A
B
E
C
E
A
6
2
3
4
5
1
7