Filter
Top Products
Page 8
Figure 8
Always unplug vacuum from outlet
before removing any clogs!
!
Clog Removal
Changing the Brush Rollers - Figures 6 & 7
To change the brush roller (#9, figure 6) or the edge-cleaning
brush roller (#9a, figure 6), release the end caps (6 and 6a, fig-
ure 6) by pushing the button (#10 for the brush roller, #10a for
the edge-cleaning brush). Rotate the end caps in the direction
of the arrows and pull them off.Turn the 8” brush roller clockwise
and the edge-cleaning roller counter-clockwise (figure 7) when
removing them from the power head.You may also reference the
arrows on the ends of the brushes which indicate the direction
to turn the brushes to remove and replace them.
To insert the new brush or brushes, fit them onto the drive shafts
by turning them clockwise until they lock into position. Replace
the end caps by turning them until they click into position. Make
sure not to squeeze the bristles of the brushes under the end
caps.
Cleaning the Brush Rollers
Unplug the vacuum before attempting to clean the brushes.
The brushes should be cleaned regularly.
Fibers and hair can be pulled out of the brushes while manual-
ly rotating the rollers, or the rollers can be removed from the
power head to clean them.
Always unplug vacuum from outlet
before dismantling any part of machine!
!
8” Replacement Brush
Part # 2754
Replacement Edge-Cleaning Brush
Part # 2756
Complete Replacement Brush Set
Part # 2758 ER
Maintenance
10a
9
Clogs in the Airflow Pathway - Figure 8
Many clogs can be removed by accessing the airflow pathway
via the orange colored access door (#11, figure 8) located on
the underside of the power head.
Clogs in the Swivel Neck
Check the swivel neck regularly for blockages. Do not open the
machine. To check for a clog in the swivel neck (#3, page 5),
remove the telescopic tube by pressing the release button (#7,
page 5). Pull the tube out of the swivel neck. Push the obstruc-
tion down the neck with a stick or long screwdriver and remove
it through the orange access door (#11, figure 8).
For clogs not in the power head, please refer to your canister
vacuum’s manual.
Figure 6
10
Figure 7
9a
6a
6
9
9a
11