Filter
Top Products
C
E
A
Page 5
1. Power head
2. Brush pressure adjustment
3. Swivel neck
4. Connection plug
5. Indicator lights
6. Brush roller end cap
6a. Edge-cleaning brush roller end cap
7. Telescopic Tube release button
Identification of Parts
1. Find the connection tab (A) at the base of the telescopic tube (B).
2. Move the connection tab (A) OUT away from the tube (C). See
enlarged detail below. It will only move approximately 1/8-inch.
NOTE: the tab must not be forced beyond the “flush” position
of the collar. Proceed to step 3.
3. Insert the base of the telescopic tube (E) into the power head
swivel neck (3). Make sure that the connection tab (A) is prop-
erly aligned with the connection plug (4) in the swivel neck.
Damage to the connection may occur if the tab and the plug
are not properly aligned.
Attaching the Power Head to
the Telescopic Tube of your
SEBO C3.1 or K3 Vacuum
A
B
E
6
2
7
4
3
1
5
6a