Filter
Top Products
Electdcal Shock Or Personal l_ury Hazard
Disconnect electrical suppty before servicing or
cteaning the unit. Failure to do so can resu# in
electrical shock _or personat injury from cleaner
suddenly starting.
TO CHECK BRUSH:
Base Support Bars
e When brushes
are worn to the
level of the base
support bars,
replace the
brushes,
TO REPLACEBRUSH:
I, Remove POWER-MATETM cover, beit and brush
assembly, (See "To remove belt" in "BELTCHANGING
AND BRUSHCLEANING" on page 13,)
2, Remove brush supports, washers, screws, end
brush, brush sprocket pieces from ends of brush
assembly.
3, Push out worn
brushes, If the
beater bar is
chipped or
gouged,
replace it,
4° Slide new
beater bar and
brushesinto
slots,
NOTE: New brush
brushes and
beater bar may
be easier to
instaiJ if they are
soaked in warm
water for a few
minutes. Dry
thoroughly
before instaiJingo
5. Reassemble brush assembly. To line up screw holes
in dowel, sprocket and end brush, be sure beater bar
portion of end brush lines up with beater bar on
brush dowel,
5. Replace belt, brush assembly, POWER-MATETM
cover, light bulb and light cover, (See "To replace
belt" in "BELTCHANGING AND BRUSHCLEANING" on
page 13,)
USH
Washer
Brush
Support
Beater Bar
Brush Dowel
Brush
Sprocket
Flange
Brush
Sprocket
Washer
Brush
Support
15