Sears 758.144131 Humidifier User Manual


 
Electrical Hook-Up
Locate nearest 120V A.C. wall socket in
the location desired, preferably on inside
wall. Plug in the electrical cord.
WARNING: To reduce the risk of fire
or shock hazard, humidifier should
be plugged into a 120V A.C. outlet.
Do not use extension cords.
To reduce the risk of electrical shock, this
humidifier has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse plug. If it still does not fit, contact
a qualified electrician to install the proper
outlet. Do not change the plug in any
way.
Water Fill
WARNING: To reduce the risk of shock,
always unplug humidifier before clean-
ing or servicing.
WARNING: To reduce the risk of fire or
shock hazard, do not pour or spill water
Into conb'of or motor area. Close the
control cover. If controls get wet, let
them dry completely and have unit
checked by an authorized service per-
sonnel before plugging in.
This humidifier is designed to be filled
using a bucket fillmethod. The unit should
be positioned where it will be operating. To
fill the 12 gallon humidifier, close the con-
trol cover and open the pivoting lid. Notice
the splash guard inside the cabinet of the
humidifier.
Use recommended mixture of cold water
and if necessary Sears Bacteriostat #42-
14900 only. Pour the water slowly from a
bucket into the cabinet onto the splash
guard. The water deflects off the splash
guard and drops into the bottom of the cab-
inet. Do not pour water onto top of unit or
control area. Standing in front of the
humidifier, notice the "PULL" labels posi-
tioned to the left and right of the splash
guard on the inner sides of the cabinet.
These labels indicate the maximum
amount of water that can be poured into
the humidifier.
Do not fill water in the cabinet above
this line. If you do, water will leak out of
the cabinet and onto the floor.
Pivoting Lid
Front of Humidifier