Filter
Top Products
Troubleshooting
TROUBLE
L/nit will not run
and FillLight is not
illuminated.
Unit will not shut
off
Unitwill notdryout
completely
Unit is not
emptying during
lee
Nater runs out of
ear of unit
PROBABLE CAUSE
• Selected humidity levet has
been established
• No power
• Float is notflee
• Float retainer positionedintop
slot at back of cabinet
• This is normal
Dirty filters
Water splashing during filling.
Too much water added
REMEDY
I- Raise humidistatsetting if desired
• Check 120 volt source for power
• Free float from obstruction
• Slide float retainer down tolowest
positionin slot at back of cabinet.
Refer to "Manual Dryout" section
on page 7.
• Asmall amount ofwater will
remain in cabinet after fill light
comes on.
• Change to fresh new filters
• Deflectfill water off the splash
guard
• Do not overfillpast "Full" labels in
cabinet
CAUTION: Use only 42-14900 EPA Registered Bacteriostat available from Sears
Retail store,
Use of other water treatment products may damage the filter elements.
Under no circumstances should you use water treatment products designed for
r3oto belt or Ultrasonic humidifiers,
13