Filter
Top Products
OPERATION
TO EMPTY THE SOLUTIONTANK
See Figure 11
When (:leaning is completed, both the Recovery Tank and the
Solution Tank should be emptied priorto storage. Empty the
Recovery Tank as described earlier. There are three methods
of emptying the Solution Tank.
Method 1:
1. Disconnect Pump Cord from Recovery Tank,
2. Remove Recovery Tank from Solution Tank and pour
solution out of the Filler Opening.
Method 2:
1. Place Floor No_le in bath tub or container.
2. Depress Solution Release Trigger and spray until empty,
Method 3:
1. Remove Floor Nozzle and insed Wand into Solution Tank
through the Filler Opening.
2. Vacuum solution out,
:3. All solution is now in Recovery Tank. Empty Recovery
Tank as described eadier.
METHOD 1
METHOD 2 METHOD 3
Fi_. 11
DRY VACUUMING
See Figure 12
ADDITIONAL USES
Your Cleaner COmes with a disposable paper dust bag to trap and collect dirt when used for dry pick up. it is very important
that the disposable paper dust bag remain clean to allow air to pass through it whiletrapping did. Ifthe dust bag isover filled
or its pores become dogged from fins powders, no air can pass through. This greatly reduces the efficiency of your cleaner
and could Pause the dust bag to burst. To maintain your cleaner's peak efficiency, check the disposable paper dust bag often
and replace when clogged or approximately one half full.
TO INSTALL DUST BAG
1. TURN POWER SWITCH OFF AND DISCONNECT
POWER CORD FROM ELECTRICAL OUTLET.
2, Lift Latches and remove Power Head from Unit.
3. Grasp Cardboard Collar of Dust Bag and push Collar as
far as possible onto Bag Adapter Tube. NOTE: For
greater ease in assembly, slide bottom of Cardboard
Collar onto Adapter Tuba first, then pull top of Collar over
Adapter Tube.
4. Position Dust Bag around sides oftank to allow motor
assembly to fit back into unit.
5, Bend top flap of Cardboard Collar inward,
6. Replace Power Head on unit, aligning the word
"VACUUM" with Hose Inlet on Recovery Tank _s shown
in F_g.10. NOTE: Be careful not to crush Dust Bag or to
deform flexible splash plate on Power Head when
assembling,
7, Unplug Short Power Cord from Recovery Tank Power
Head. (See FTgure 2, page 4)
CARDBOARD
COLLAR
DUST
BAG
BAG ADAPTER
TUBE
_g. 12
c;IUTIoN: PAPER DUST BAG IS FOR DRY PICK UP
ONLY. DO NOT USE WHEN VACUUMING UP WATER OR
OTHER LIQUIDS!