Filter
Top Products
OPERATION
TEST FOR SOLUTION SPRAY
See FTgure 6
1. Hold Floor Nozzle above floor level.
2. Pull Solution Release Trigger on Angled Wand.
3. Observe Floor Nozzle to make sure oleaning solution
is being sprayed evenly. (see DETAIL _A")
NOTE: If solution is not being sprayed evenly, refer to
Trouble Shooting Chad.
CLEANING THE CARPET
See F_gures 7 & 8
Solution Dispensing Stroke:
1, Sfad at a comer (recommended).
2. Place Roor Nozzle so Suction Inlets are flush with
carpet.
3. While exerting light pressure down on Floor Nozzle,
depress Solution Release trigger and slowly pull
Roor Nozzle towards you,
NOTE: Do not overwet. Ifthree or more cleaning strokes
are required, let dry and then repeat cleaning proc-
ess.
Solution Recovery Stroke:
1. Release Solution Release Trigger.
2. Lift Floor Nozzle off carpet.
3, Return Floor Nozzle to point where you dispensed
cleaning solution and pull across carpet, recovering
dirtysolution.
SOLUTION
RELEASE
TRIGGER
FLOOR
sPRAYS OF
SOLUTION
SUCTION INLETS
Rg. 7
LIFT.
SET FORWARD,
PULL BACK ACROSS CARPET
|
I
I
Fig. 8