Filter
Top Products
TROUBLE SHOOTING CHART
PROBLEM POSSIBLE SOLUTIONS*
1. Neither vacuum motor nor pump
motor runs.
2. Vacuum motor runs, but there is no
spray at the nozzle.
3. Spray from the floor nozzle comes
out of one side of the nozzle only.
4. Motor runs butcleaner does not pick
up ,=',lutionfrom carpet (no exhaust
from top of cleaner).
i . , .j,i J,
5. Spray connections leak.
1. Be sure power switch is in "ON" position_
2. Be sure power cord is plugged in securely.
3. Check wall electrical outlet (by plugging in a known
working electrical appliance).
1. Be sure Electrical Cord from Power Head to Solution
Tank is securely plugged into receptacle on the Power
Head.
2. Check that Solution Tank is full.
3. Be sure Pump Switch is in the "HI"or "LO" position.
4. Nozzle Ports may be clogged. See illustration below to
unclog.
1. Unclog the Nozzle Pod. See illustration below.
1. Recovery Tank isfull of dirty water and must be emptied.
2/Check for clogged hose or nozzle. Clogs could result from
picking up material such as carpet strings, shoe laces,
etc.
1. Disassemble nut at leaking connection. Be sure washer
is properly seated. Reassemble and tighten securely.
"If the "Possible Solutions" to"Problem,s"listedin the chartdo notcorrectthe problem, take your cleaner toa Sears
Sen/ice Center for professional service, Repairs not listed in this chart require professional and specific
knowledge of this model cleaner and could result In safety hazards and pemonal injury' if not made by a
qualified Sea_ Service Technician.
TO UNCLOG NOZZLE PORT
See FTgure 16
1. Insert the point of a needle or pin into
Spray Port to unclog.
NOTE: Do not let the point of needle or pin
touch any part of the Spray Pad surface or
Spray Pad will not spray solution properly.
SPRAY PORT
.,,, ,, L .... i
CAUTION: Do not let needle
or pin touch this surface.
NEEDLE OR
PIN
Fig. 16